173 Results Found
Spanning Tree Protocol (STP) is dead, or at least it should be. It’s too slow to converge when there’s a change, and it causes issues with performance because there is only one forwarding path. It was developed in 1985 by Radia Perlman at Digital Equipment Corporation to allow for redundant paths within a Layer 2 topology, which was great in 1985. In fact, it was huge! So much so, that it was later standardized by the IEEE as 802.1D, and we’ve been living with it ever since.
The short answer (and a common one in our industry): it depends. When comparing Cisco IOS with Juniper Junos, the decision to choose one over the other is difficult and often boils down to cost. Of course, there are other factors to consider.
In my last post, we learned that the Dynamic Host Configuration Protocol (DHCP) is a computer networking protocol used by hosts, identified as DHCP clients, to retrieve IP address assignments and other configuration information. DHCP uses a client-server architectur...
This is another topic of heated debate, and it changes from network to network, but I found a simple approach that works in most cases. Since I have four queues and four classes of traffic, I need to categorize my important traffic into four classes. Strictly for explanation purposes I took some liberty in defining four categories of traffic that are very effective in both large and small networks. These classes are: Real Time Protocol (RTP), Network Management (NetMgt), Business Critical, and the Default.
With the advent of video use in our everyday communications, a number of questions commonly surface. One of them is the question of terminology. What's the difference between video conferencing and telepresence? What is meant by immersive technologies? Frankly, there is no one single right answer.
The most obvious difference is that hubs operate at Layer 1 of the OSI model while bridges and switches work with MAC addresses at Layer 2 of the OSI model. Hubs are really just multi-port repeaters. They ignore the content of an Ethernet frame and simply resend every frame they receive out every interface on the hub. The challenge is that the Ethernet frames will show up at every device attached to a hub instead of just the intended destination (a security gap), and inbound frames often collide with outbound frames (a performance issue).
The Cisco UCS is truly a “unified” architecture that integrates three major datacenter technologies into a single, coherent system: Computing Network Storage Instead of being simply the next generation of blade servers, the Cisco UCS is an innovative architecture designed from scratch to be highly scalable, efficient, and powerful with one-third less infrastructure than traditional blade servers.
Learn about the five types of area networks.
That depends on their configurations. For example: While it makes very good sense to include redundant physical links in a network, connecting switches in loops, without taking the appropriate measures, will cause havoc on a network. Without the correct measures, a switch floods broadcast frames out all of its ports, causing serious problems for the network devices. The main problem is a broadcast storm where broadcast frames are flooded through every switch until all available bandwidth is used and all network devices have more inbound frames than they can process.
According to Cisco marketing, Dynamic Multipoint VPN (DMVPN) “will lower capital and operation expenses, simplifies branch communications, reduces deployment complexity, and improves business resiliency.” Okay. But what is it, really, and why should we care?
The key difference between hubs, switches and bridges is that hubs operate at Layer 1 of the OSI model, while bridges and switches work with MAC addresses at Layer 2 of the OSI model.
Software-defined networking (SDN) is a solution that will enable your organization to meet the demands of network programmability and automation. The result will be greater network agility to support new applications while complying with increasing security needs.
Global Knowledge Course Director and Lab Topology Architect Joey DeWiele, a specialist in Unified Communications, discusses Cisco Unity, Unity Connection & Unity Express.
In the previous post, we discussed the need for VXLAN in the cloud along with the issues it solves. In this post, we will focus more on how VXLAN works.
There are some common misconceptions on the part of some of my students as to how VPN sessions are established from either a remote location or remote user to the ASA firewall. In particular, a “gray area” seems to be when the attributes from the tunnel group are app...
There are many interesting new issues that seem to have come with the addition of voice and video to the data network. Most of the engineers that are now working on VoIP networks come from either a pure data network background or a traditional phone system background...
When properly utilized, VLANs and trunks provide flexibility, stability and ease of troubleshooting. This paper provides technical details about VLANs and trunks, along with design options at a basic to intermediate level. Recommendations and commands are included throughout.
RTMT provides a set of canned views of both system resources and application counters that provide you with a snapshot of your environment right out of the box. Read on to learn how you can make RTMT even more helpful by customizing it to show you different views of your resources and CUCM environment.
Occasionally as I'm teaching a Cisco training class, I get an idea for a blog post and it happened again this week. The Securing Networks with ASA Fundamentals curriculum is mostly based on the Adaptive Security Device Manager (ASDM). While the class describes the us...
So far, in our discussion of Router Information Protocol (RIP), we’ve discussed the basics and also verified and reviewed RIP version1. We stated that RIP version 1 is a classful routing protocol that used FLSM and sent it routing updates without the subnet mask. In...
Next Hop Resolution Protocol enables businesses to have a way for next-hop servers and next-hop clients to communicate with each other directly, bypassing a central hub and preventing potential bottlenecks.
The responsibility for securing organizational data has spread beyond the traditional IT professional. While there are more diverse security solutions, there are more diverse and sophisticated security threats. Security awareness and training is essential for everyone within an organization. Learn how Cisco has continued to evolve its security solutions and training.
Where should you apply the CSS, and why are there two places to apply it? One approach is to pick one of the parameters and apply the permissions there. Quite often, an administrator will pick the phone-level CSS and configure it there so that it applies to all calls made from all lines. The goal is to specify what partitions are allowed to be called.
John Barnes, Global Knowledge's Cisco Course Developer, discusses enhancements to our UCS Troubleshooting Boot Camp and suggestions for students in preparation for this course.
Last blog we looked at how we can use Trunk groups to ease the configuration of dial-peers and digit manipulation using analog FXO ports for an E911 solution. Now let’s take a look on how it can be used for T-1 CAS configurations and ISDN channel selection. The firs...
One aspect of Unified Communications is this concept of trunk groups. I will discuss what they are, what benefit they can provide and how to configure them for Cisco gateways. First of all the official definition of a trunk group is “A group of trunks serving the s...
Global Knowledge subject matter experts predict the top trends for 2020 in IT training, Microsoft, Cisco, AWS, cybersecurity and more.
Managers are in dire need of cybersecurity professionals with specific skills. If you’re looking to advance your career, or transfer into the cyber field, now is the time to get certified.
Discover the top 5 highest-paying and popular Cisco certifications from the IT Skills and Salary Report. Learn how to get certified and unlock IT career opportunities.
IT is a very fast changing industry – what is hot today may be a tiny niche market in only a few years and lesser known things may turn out to be huge trends. That having been said, there are many certifications that will be around for a long time. However, this does not imply that recertification and/or continuing education credits are not required to maintain certification. Predicting the future is always challenging, including in IT, but these certifications are good bets.
I recently came across an opportunity to use a relatively new feature in Cisco Unified Communications Manager (CUCM). Suppose you are the telecom administrator at a community hospital. During business hours, the Facilities Department is staffed and team members simpl...
One command that had a fairly long history first with the PIX Firewall and now the ASA is the shun command. In this post we’ll examine this command’s history, why it’s useful, and its new-found resurgence in threat detection implementation.
If you’re in IT, you’ve likely heard the saying, “In technology, the only thing constant is change itself,” and boy is that right! For technical companies, if you are not moving forward, then you’re falling behind. There is no such thing as standing still! A perfect example of this mindset is in Cisco’s evolution of video conferencing and telepresence.
In light of the recent tragic events in Haiti, it might be a good time to review some of the requirements for a well designed Uninterruptible Power Source (UPS) to be included in all of our critical network installations. As a CCNA, we are called upon to help maintai...
Interior Gateway Routing Protocol (IGRP) was a Cisco-proprietary Distance-Vector (D-V) classful routing protocol - basically an improved version of RIPv1. Like other D-V protocols, each IGRP router periodically flooded its routing table, but it differed from RIP in two ways. First, RIP’s advertisement interval was thirty seconds but IGRP’s was ninety seconds, which allowed IGRP to scale to larger networks than RIP. Second, RIP used a simple hop count metric, but IGRP’s more sophisticated metric was based on minimum path bandwidth and total path delay, with options to include link reliability and interface loading.
In 2013, Cisco released their Software Defined Networking (SDN) solution for the data center known as Cisco Application Centric Infrastructure (ACI). For many years, the networking industry has been asking for an approach to configuring networking devices more efficiently than having to individually configure each and every router and switch.
Moving data from one networked device to another requires several different functions. Each function has its own protocol or protocols that define how it is accomplished. Also, the process of delivering data from one device to another can vary. The main factor in data delivery is determining whether the two devices are directly connected or remotely connected.
Moving data from one networked device to another requires several different functions. Each function has its own protocol or protocols that define how it is accomplished. Also, the process of delivering data from one device to another can vary. The main factor in data delivery is determining whether the two devices are directly connected or remotely connected.
Like it or not, Internet of Things (IoT) is upon us. There are a number of factors that will impact its adoption rate, and the inevitable privacy (or lack of) discussions will likely happen sooner than later. This is going to change the world as we know it, in many cases for the better. But we will need to keep an eye on the extent to which it invades our personal lives if it is going to be the positive force it has the potential to be.
Cisco Access Control Lists (ACLs) are used in nearly all product lines for several purposes, including filtering packets (data traffic) as it crosses from an inbound port to an outbound port on a router or switch, defining classes of traffic, and restricting access to devices or services. Knowing how to design, configure, and troubleshoot ACLs is required for all network engineers working within a Cisco network.