178 Results Found
The Cisco UCS is truly a “unified” architecture that integrates three major datacenter technologies into a single, coherent system: Computing Network Storage Instead of being simply the next generation of blade servers, the Cisco UCS is an innovative architecture designed from scratch to be highly scalable, efficient, and powerful with one-third less infrastructure than traditional blade servers.
The most obvious difference is that hubs operate at Layer 1 of the OSI model while bridges and switches work with MAC addresses at Layer 2 of the OSI model. Hubs are really just multi-port repeaters. They ignore the content of an Ethernet frame and simply resend every frame they receive out every interface on the hub. The challenge is that the Ethernet frames will show up at every device attached to a hub instead of just the intended destination (a security gap), and inbound frames often collide with outbound frames (a performance issue).
With the advent of video use in our everyday communications, a number of questions commonly surface. One of them is the question of terminology. What's the difference between video conferencing and telepresence? What is meant by immersive technologies? Frankly, there is no one single right answer.
This is another topic of heated debate, and it changes from network to network, but I found a simple approach that works in most cases. Since I have four queues and four classes of traffic, I need to categorize my important traffic into four classes. Strictly for explanation purposes I took some liberty in defining four categories of traffic that are very effective in both large and small networks. These classes are: Real Time Protocol (RTP), Network Management (NetMgt), Business Critical, and the Default.
In my last post, we learned that the Dynamic Host Configuration Protocol (DHCP) is a computer networking protocol used by hosts, identified as DHCP clients, to retrieve IP address assignments and other configuration information. DHCP uses a client-server architectur...
Global Knowledge instructor Kevin Schweers reviews the basic differences between the two paths to achieving CCNA certification.
The short answer (and a common one in our industry): it depends. When comparing Cisco IOS with Juniper Junos, the decision to choose one over the other is difficult and often boils down to cost. Of course, there are other factors to consider.
Spanning Tree Protocol (STP) is dead, or at least it should be. It’s too slow to converge when there’s a change, and it causes issues with performance because there is only one forwarding path. It was developed in 1985 by Radia Perlman at Digital Equipment Corporation to allow for redundant paths within a Layer 2 topology, which was great in 1985. In fact, it was huge! So much so, that it was later standardized by the IEEE as 802.1D, and we’ve been living with it ever since.