• About Us
  • All Categories
  • Contact
  • Home
  • Our Authors
  • Partner Quizzes (Testing) > Sirius Computer Solutions
  • Global Knowledge Blog Global Knowledge Blog

--

  • Home
  • All Categories
  • Our Authors
  • About Us
  • Global Knowledge Blog
  • Home
  • All Categories
  • Our Authors
  • About Us

CCNP Data Center Question of the Week: Cisco IMC

By Johnny Bass
September 23, 2016

ccnpQoW01

If you select Shared LOM NIC mode in the Cisco IMC Configuration Utility, which ports can access the Cisco IMC?

A. The ports on an installed Cisco network adapter card
B. The two 1-Gb Ethernet ports
C. The two 10/100 management ports
D. The two 10/100 management ports, but each port must be at defaults

Reveal Answer

Answer: B.

When you select the LAN on Motherboard NIC, then the two 1-Gb Ethernet ports are used.  Note, on the newer platform, there may be a single 10Gig Ethernet port, therefore which would be the port used on those platform.

 

Related Courses
DCUCI – Data Center Unified Computing Implementation v5.0
DCUFI – Implementing Cisco Data Center Unified Fabric v5.0
DCUCD – Designing Cisco Data Center Unified Computing v5.0
DCUFD – Designing Cisco Data Center Unified Fabric v5.0
DCUCT – Troubleshooting Cisco Data Center Unified Computing v5.0
DCUFT – Troubleshooting Cisco Data Center Unified Fabric v5.0

Related Certification
CCNP Data Center

In this article
  • CCNP
  • Certification
  • Cisco
  • Data Center
  • ccnp certification
  • ccnp exam prep

Join the Conversation Cancel Reply

Will not be published.


RELATED ARTICLES

  • CCNP R&S Question of the Week: IPsec Modes

    Which IPsec mode will encrypt a GRE tunnels and reduced overhead?
    By Johnny Bass June 3, 2016
  • CCNP R&S Question of the Week: Gateway of Last Resort

    Refer to the exhibit below. Why is the 140.140.0.0 network not used as the gateway of last resort even though it is configured first? Select the best response.
    By Johnny Bass March 20, 2015
  • CCNP Security Question of the Week: NTP on a Cisco…

    Which three options are default settings for NTP on a Cisco ASA? (Choose three.)
    By Johnny Bass February 5, 2016

CONNECT WITH US

CATEGORIES

Back to top

© 2019 Global Knowledge Training LLC. All Rights Reserved.  Site Admin | Logout