CCNP R&S Question of the Week: Private VLANs

By Johnny Bass

April 10, 2015

What should you complete first when configuring private VLANs?

A. Configure the private VLAN port parameters.
B. Configure and map the secondary VLAN to the primary VLAN.
C. Disable IGMP snooping.
D. Set the VTP mode to transparent.

Reveal Answer

Related Resources
Cisco White Papers

Related Course
CCNP Routing and Switching e-Camp

Join the Conversation Cancel Reply

CCNP R&S Question of the Week: Interface FastEthernet0/1

Interface FastEthernet0/1 is configured as a trunk that permits all VLANs. The following command is configured: monitor session 2 filter vlan 1 - 8, 39, 52. What is the result...
By Johnny Bass May 20, 2016
CCNP R&S Question of the Week: BPDU Guard

Why is a Bridge Protocol Data Unit (BPDU) guard an effective way to prevent a rogue switch from joining a network?
By Johnny Bass April 3, 2015
CCNA Data Center Question of the Week: Virtual Device Contexts

Which is a key characteristic of virtual device contexts?
By Johnny Bass January 2, 2015

CCNP R&S Question of the Week: Private VLANs

In this article

Join the Conversation Cancel Reply

CCNP R&S Question of the Week: Interface FastEthernet0/1

Interface FastEthernet0/1 is configured as a trunk that permits all VLANs. The following command is configured: monitor session 2 filter vlan 1 - 8, 39, 52. What is the result...

CCNP R&S Question of the Week: BPDU Guard

Why is a Bridge Protocol Data Unit (BPDU) guard an effective way to prevent a rogue switch from joining a network?

CCNA Data Center Question of the Week: Virtual Device Contexts

Which is a key characteristic of virtual device contexts?