Worldwide Locations
180 Results Found
Global Knowledge Course Director and Lab Topology Architect Joey DeWiele, a specialist in Unified Communications, explains the difference between our Cisco Unified Communications courses - ACUCW1 & ACUCW2.
When sending data end-to-end through a network, routers are used in internetworking to create a virtual network from one device to another, either locally or globally. Routers are configured to operate with most common network protocols. That means they know the form...
This hour-long, information-packed webinar will provide tips and tricks for modifying and optimizing router path selection with EIGRP and OSPF. You will learn about EIGRP redistribution, including redistributing static routes into EIGRP, and about OSPF redistribution. You'll learn about using route maps and prefix lists and about summarization with EIGRP and OSPF. Also, you will receive tips for controlling updates and path selection.
What is Network Time Protocol (NTP)? Well, it’s a network protocol used to synchronize clocks between computing systems over a packet switched network. It’s been around since the mid-1980s and was developed by David Mills at the University of Delaware; it is one of the oldest protocols still around on the Internet. NTP replaced other time synchronization technologies that didn’t have some capabilities to adjust time based on location of the time source or time server relative to the receiver or adjusting to the variation of delay found on typical data networks.
The subject of this week’s post was actually prompted by a question from a former colleague. Soon after the PIX Firewall added support for IPSec Virtual Private Networks, a command was added to the command-line, sysopt connection permit-ipsec. This command was subse...
I recently was presented with the challenge of logging ALL of the pertinent connection, disconnection, and termination messages associated with the Cisco SSL AnyConnect client without overwhelming the syslog capture display with extraneous messages. This blog will br...
As is sometimes the case, the idea for this article originated with a student question I received during one of the Securing Networks with ASA Fundamentals classes I have taught this summer. The course material mentions a simple scenario whereby IP Telephony traffic...
As is frequently the case these days, I get a brainstorm for an article during a Cisco Security training class I conduct. This summer I taught the Securing Networks with ASA Fundamentals class, which concentrates heavily on the Adaptive Security Device Manager (ASDM)...
RIP is a protocol that is used for routing IP networks. It was designed in the early 1980’s for communication between gateways (computers with two NIC’s). It is the oldest routing protocol used by the network industry and is considered by many to be inefficient or bo...
In this post I’ll focus on a topic that’s mentioned in the Cisco FIREWALL training class but isn’t emphasized there or in the online Cisco ASA documentation. When configuring failover on a pair of ASA security appliances, a situation can arise in which network disruption occurs due to the secondary ASA in a failover pair becoming active first and then the primary comes online second. Both the documentation and the courseware point out that this causes the secondary (and active ASA) to swap its interface MAC addresses with those of the primary. Being naturally skeptical about this behavior, I decided to investigate. The rest of this post illustrates my confirmation of this phenomenon.