Is your salary on par with others in your field? Learn more in Skillsoft's 2024 IT Skills and Salary Report. Click Here.

Checkout

Cart () Loading...

    • Quantity:
    • Delivery:
    • Dates:
    • Location:

    $

Contact Sales

Resource Library

Filter By
Show Filters
Result Filters:

519 Results Found

Results per page: 10 40 80

Call Admission Control

Article | Aug. 20, 2009

Call Admission Control (CAC) is often times included as part of the same topic as Quality of Service (QoS), when in actuality CAC is a separate and complete topic itself. QoS is defined as traffic engineering on a packet switched network. This definition means movin...

Exchange 2010 Transport Fundamentals

Article | Aug. 17, 2009

Exchange 2010 builds upon the significant changes to the transport that were made in Exchange 2007. In this article, I'll review the transport pipeline and routing components and list some of the new architectural and administrative enhancements to the Exchange 2010...

RFC 2833 and DTMF Relay

Article | Aug. 12, 2009

Devices must send dual-tone-multi-frequency (DTMF) when a phone call is routed to an automated system. Automated attendant (AA), voicemail (VM), or interactive voice response (IVR) systems are some examples of the types of automated systems that can pick up phone calls.

Understanding RIP v2

Article | Aug. 05, 2009

So far, in our discussion of Router Information Protocol (RIP), we’ve discussed the basics and also verified and reviewed RIP version1. We stated that RIP version 1 is a classful routing protocol that used FLSM and sent it routing updates without the subnet mask.  In...

Basics of Understanding RIP

Article | July 30, 2009

RIP is a protocol that is used for routing IP networks. It was designed in the early 1980’s for communication between gateways (computers with two NIC’s). It is the oldest routing protocol used by the network industry and is considered by many to be inefficient or bo...

FTP vs. TFTP

Article | July 15, 2009

Recently we've been comparing using Telnet with Secure Shell protocol to allow remote access to a device such as a router or switch. Now, we're going to compare File Transfer Protocol (FTP) and Trivial File Transfer protocol (TFTP) for a Cisco router or switch. These...

Static Routing

Article | July 14, 2009

You may have noticed that it’s the dynamic routing protocols that get all the glory. Since I like rooting (routing?) for the underdog, let’s talk about static routes! As you may recall, a router has three methods for learning a route. A route can appear in the routi...

Calculating VoIP Bandwidth

Article | July 08, 2009

When integrating a Voice over IP (VoIP) system into an existing network it is very important to have a good understanding of how much bandwidth is utilized for each call on the network. For most people, just starting out the bandwidth calculations can be a very daunt...

E.164 – The modern dial plan

Article | July 02, 2009

When we are addressing Voice over IP we need to remember that essentially we would like to reach customers over the PSTN or SS7 network. The only avenue to date to do this, is by using something called the telephone number. However, that number has undergone some cha...

Access Control Lists (ACLs) – Part 6

Article | June 23, 2009

As you may recall, we can use extended IP ACLs to filter packets based on source address, destination address, transport layer protocols, and other options, as follows: access-list 106 permit tcp host 1.2.3.4 host 5.6.7.8 eq telnet For a packet to be permitted by...